CUBE SOLID STATE, 1AMP, HOT INITIATE SWITCH

TH3PL Timers

TGC Delay on Make Relay Timer 10-30 Amps

Timing Mode | Single Shot on Make

Category | Solid State Timer

Series | TH3PL

TH3PL are solid state output Single Shot timers in a fully encapsulated 2" x 2" case.

Available with factory-fixed time or adjustable via on-board potentiometer or external resistor.

Timing Mode

Power must be applied to the input voltage terminals continuously. Upon closure of a Normally Open (N.O.) external initiate switch, the load is instantaneously energized and the time delay cycle starts.

Maintained closure or actuation of the external initiate switch during the delay cycle will not affect the time delay period.

When the delay period expires, the timer will reset to its original position and the timer is ready for another cycle.

Cube Relay, 10-30 Amps, Timer with Relay Output
  • Digital timing, solid state output
  • 1 Amp current handling
  • 10 Amps single AC cycle surge handling
  • ±0.1% Repeat accuracy
  • Factory-fixed or variable timing adjustment
  • Single screw mounting through center mounting hole
  • Standard 6.35 mm (0.25”) quick connect blade terminals
  • 100% Operational testing before shipping
  • RoHS compliance available
Solid State DC Voltage
  • Input Voltage
    VAC: 24, 120
    VAC: 230 VAC (±20%)
    VDC: 12 or 24
  • Initiate
    Switch line voltage
  • Time Delay
    0.1 second to 24 hours (1 sec., 10 sec., 100 sec., and 1000 sec. are standard)
    Any time range available upon request
  • Repeatability
    ±0.1% under fixed conditions
  • Reset/Recycle Time
    150 milliseconds maximum
  • Initiate Time
    16 milliseconds
  • Solid State Output Form
    Normally open 1 Amp steady state, 10A single cycle surge
  • Life Expectancy
    No predictable failure if used within operating parameters
  • Protection
    Transient Protection: 18 joules
    Dielectric Strength: 1800V RMS 60Hz
  • Temperature Ranges:
    Storage: -40°C to +85°C
    Operating: -25°C to +65°C
  • Physical Data
    Surface mount with single #8 or #10 screw, totally encapsulated