MINIATURE CUBE SOLID STATE, DC VOLTAGE

TBK Miniature Timers

TGC Delay on Make Relay Timer 10-30 Amps

Timing Mode | Repeat Cycle, Off/On Delay

Category | Solid State Timer

Series | TBK

TBK timers are solid state output units with digital timing and come in a 1 5⁄8" square case. They are available for 8-40 VDC.

Ease of installation and hook-up is a primary design benefit. All models are available with integral time adjustment knob or factory-fixed time, and require only three connections.

Timing Mode

Application of input voltage to the timer starts the “Off” time delay.

At the end of the “Off” time delay, the “On” time delay starts, and the load is energized.

At the end of the “On” time delay, the load is de-energized, the timer returns to the “Off” time delay, and cycling continues as long as input voltage is applied.

Removal of the input voltage resets the timer.

Cube Relay, 10-30 Amps, Timer with Relay Output
  • Digital timing, solid state MOSFET output
  • 1 Amp current load handling
  • 10 Amps 100 ms (millisecond) surge handling
  • Wide DC voltage range
  • ±0.1% Repeat accuracy
  • Virtually unlimited time ranges
  • Factory-fixed or variable timing adjustment
  • Totally encapsulated for protection from harsh environments
  • O-ring sealed exposed controls
  • Single #6 screw mounting through center mounting hole
  • Standard 6.35mm (0.25") quick connect blade terminals
  • 100% Operational testing before shipping
  • RoHS compliance available
Solid State DC Voltage
  • Repeat Accuracy
    ±0.1% under fixed conditions
  • Timing Ranges
    0.1 sec. to 24 hours (1 sec., 10 sec., 100 sec., and 1000 secs. are standard.)
    Special time ranges available upon request
  • Reset/Recycle Time
    100 milliseconds
  • Tolerances
    Fixed: ±10% of nominal time
    (optional: ±5%, ±1%)
    Variable: -0%, +15%
    Limit: -10% at minimum time
  • Recycle Effect
    None
  • Temperature Ranges
    Storage: -40°C to +85°C
    Operating: -25°C to +65°C
  • Life Expectancy
    No predictable failure if used within operating parameters
  • Protection
    Polarity Protection: All DC units have reverse polarity protection
    Transient Protection: 18 joules
    Dielectric Strength: 1800V RMS 60Hz
  • Power Requirement
    0.25 watts max
  • Weight
    3oz. (85g) maximum
  • Solid State Output
    SPST (N.O.)
  • Load Current
    1 amp continuous, 10 amps 100 ms surge
  • Time Cycle Interrupt (Input Voltage Break)
    Resets timer to original state