MISSING PULSE DETECTOR / WATCHDOG

TGMPL Timers

TGC Delay on Make Relay Timer 10-30 Amps

Timing Mode | Retriggerable Single Shot

Category | Timer with Relay

Series | TGMPL

TGMPL series Cube Relay Single Shot timers are a unique combination of digital CMOS timing circuitry with a relay output in a compact 2” x 2” configuration. These units provide the same functional performance as plug-in relay timers, but at significant cost savings.

Timing Mode

Input voltage is applied continuously - when control switch closes the relay transfers, if switch closures happen within set time period, relay stays closed. If control switch stays closed or open longer than set time, relay opens.

Cube Relay, 10-30 Amps, Timer with Relay Output
  • High current-carrying capacity up to 10 amps
  • Transient protected
  • 100% Load isolation
  • No leakage in N.O. position
  • No heat sinking required
  • Available in any time delay period required
  • Digital CMOS timing
  • No minimum load required
  • Totally encapsulated for protection from harsh environments
  • 100% Operational testing before shipping
  • RoHS compliance available
Solid State DC Voltage
  • Input Voltage
    VDC: 12, 24 or 48
    VAC: 24, 48, 120 or 230, 50/60Hz
  • Time Delay
    Timing Mode: Pulse Detector
    Type: Digital CMOS
    Time Range: 0.2 second to 24 hours
    Time Adjustments: Factory-fixed time period; variable, with adjustments on timer, or terminals for external resistor or potentiometer
  • Repeatability
    ±0.5%
  • Setting Accuracy
    Fixed time period: ±10% of nominal time
    Variable time range: +15% -5% max. time, -10% min. time
  • Reset/Recycle Time
    25 milliseconds
  • Initiate Time
    6 milliseconds or less
  • Relay Life Expectancy
    Mechanical: 20 million operations
    Electrical: 100,000 operations at maximum load
  • Protection
    Polarity Protection: All DC units have reverse polarity protection
    Transient Protection: 18 joules
    Dielectric Strength: 1800V RMS 60Hz
  • Temperature Ranges
    Storage: -40°C to +85°C
    Operating: -25°C to +65°C
  • Physical Data
    Mounting: Surface with one #8 screw
    Connection & Termination: 0.25" quick connects

    • Note: When using a proximity switch for control unit, a snubber may be required to bypass leakage current